is properly initialized and available in all cases (like ompi_info, where
the ess is never actually initialized). Fixes trac:1364.
This commit was SVN r18733.
The following Trac tickets were found above:
Ticket 1364 --> https://svn.open-mpi.org/trac/ompi/ticket/1364
This commit ensures that attempts to access information that is unknowable or undefined returns appropriate invalid or not_supported values to avoid unexpected behavior and/or segfaults.
This commit was SVN r18692.
Ensure that routes to remote procs are set on the HNP before completing launch so that the debugger message can be sent. Solves a race condition that can exist in those environments where the HNP does not have local procs.
This commit was SVN r18674.
Update the ESS API so we can update the stored arch's should the modex include that info. Update ompi/proc to check/set the arch for remote procs, and add that function call to mpi_init right after the modex is done.
Setup to allow other grpcomm modules to decide whether or not to add the arch to the modex, and to detect if other entries have been made. If not, then the modex can just fall through. Begin setting up some logic in the "basic" module to handle different arch situations.
For now, default to the "bad" module so we will work in all situations, even though we may be sending around more info than we really require.
This fixes ticket #1340
This commit was SVN r18673.
Some minor changes to help facilitate debugger support so that both mpirun and yod can operate with it. Still to be completed.
This commit was SVN r18664.
This commit repairs the debugger initialization procedure. I am not closing the ticket, however, pending Jeff's review of how it interfaces to the ompi_debugger code he implemented. There were duplicate symbols being created in that code, but not used anywhere. I replaced them with the ORTE-created symbols instead. However, since they aren't used anywhere, I have no way of checking to ensure I didn't break something.
So the ticket can be checked by Jeff when he returns from vacation... :-)
This commit was SVN r18625.
The following Trac tickets were found above:
Ticket 1255 --> https://svn.open-mpi.org/trac/ompi/ticket/1255
After much work by Jeff and myself, and quite a lot of discussion, it has become clear that we simply cannot resolve the infinite loops caused by RML-involved subsystems calling orte_output. The original rationale for the change to orte_output has also been reduced by shifting the output of XML-formatted vs human readable messages to an alternative approach.
I have globally replaced the orte_output/ORTE_OUTPUT calls in the code base, as well as the corresponding .h file name. I have test compiled and run this on the various environments within my reach, so hopefully this will prove minimally disruptive.
This commit was SVN r18619.
Add a new function to opal_progress that tells us our recursion depth to support that solution.
Yes, I know this sounds picky, but good ol' Jeff managed to make it happen by driving his cluster near to death...
Also ensure that we declare "failed" for the daemon job when daemons fail instead of the application job. This is important so that orte knows that it cannot use xcast to tell daemons to "exit", nor should it expect all daemons to respond. Otherwise, it is possible to hang.
After lots of testing, decide to default (again) to slurm detecting failed orteds. This proved necessary to avoid rather annoying hangs that were difficult to recover from. There are conditions where slurm will fail to launch all daemons (slurm folks are working on it), and yet again, good ol' Jeff managed to find both of them.
Thanks you Jeff! :-/
This commit was SVN r18611.
Also detect orted failed-to-start by setting timeout on launch. Currently only used in TM launcher.
Neither detection is enabled by default, but are only active if heartrate is set and/or launch timeout is set. Exception for SLURM as orted failure is always detected and reported.
More info to come on devel list.
This commit was SVN r18555.
1. it depends upon the ability of the native environment to alert us that the orted has died/failed to start. I have included that support for SLURM, but other environments need to be done.
2. for some yet-to-be-determined reason, the message that tells the remaining daemons to "die" isn't getting out of the RML, even though no obvious blockage is standing in the way. Work will continue on resolving that problem. For now, the orteds appear to be exiting on their own quite nicely when they see their HNP "lifeline" disappear.
This represents the best-available fix for ticket #221 so I am closing that ticket at this time.
This commit was SVN r18536.
The former will return a valid item in the list, the latter will return an invalid item that marks the end of the list.
It was happending that when oversubscribing by way of an appfile we would cause a segv because we tried to interpret the invalid item returned by "opal_list_get_end" instead of a valid item. We would then try to write to unallocated memory.
This commit fixes trac:1279
This commit was SVN r18529.
The following Trac tickets were found above:
Ticket 1279 --> https://svn.open-mpi.org/trac/ompi/ticket/1279
