of Fortran datatypes (mpif-common.h) and the list of registered
datatypes: MOOG(REAL2).
Configure and Compilation with ia32/gcc just finished, naturally
without real2.
This commit was SVN r15137.
interface:
- Fix the handling of MPI_BOTTOM in various places
Update of r15030
- While being at it, handle MPI_IN_PLACE in the same way.
Convert OMPI_ADDR -> OMPI_F2C_BOTTOM
Convert OMPI_IN_PLACE -> OMPI_F2C_IN_PLACE
and have them converted before the actual call.
- Approved by George and tested with icc and simple f77 mpi-program and
with program by Daniel.
This commit was SVN r15129.
The following SVN revision numbers were found above:
r15030 --> open-mpi/ompi@15f9e58c68
-I for ${includedir}/openmpi. Solves many problems, and with just a tad
bit of hackery. Don't know why I didn't just do this earlier.
Refs trac:542
This commit was SVN r14853.
The following Trac tickets were found above:
Ticket 542 --> https://svn.open-mpi.org/trac/ompi/ticket/542
Do not initialize them, if not.
If initializing them, check for the correct C-equivalent type
to copy from...
Issue a warning, when a type (e.g. REAL*16) is not available to
build the type (here COMPLEX*32).
This fixes issues with ompi and pacx.
Works with intel-compiler and FCFLAGS="-i8 -r8" on ia32.
This commit was SVN r14818.
The following SVN revision numbers were found above:
r8 --> open-mpi/ompi@e952ab1f88
via the visibility feature that is provided by some compilers.
Per default this feature is disabled, to enable it you need to
configure with --enable-visibility and obviously you need a compiler
with visibility support. Please refer to the wiki for more information.
https://svn.open-mpi.org/trac/ompi/wiki/Visibility
This commit was SVN r14582.
* Remove the connect() timeout code, as it had some nasty race conditions
when connections were established as the trigger was firing. A better
solution has been found for the cluster where this was needed, so just
removing it was easiest.
* When a fatal error (too many connection failures) occurs, set an error
on messages in the queue even if there isn't an active message. The
first message to any peer will be queued without being active (and
so will all subsequent messages until the connection is established),
and the orteds will hang until that first message completes. So if
an orted can never contact it's peer, it will never exit and just sit
waiting for that message to complete.
* Cover an interesting RST condition in the connect code. A connection
can complete the three-way handshake, the connector can even send
some data, but the server side will drop the connection because it
can't move it from the half-connected to fully-connected state because
of space shortage in the listen backlog queue. This causes a RST to
be received first time that recv() is called, which will be when waiting
for the remote side of the OOB ack. In this case, transition the
connection back into a CLOSED state and try to connect again.
* Add levels of debugging, rather than all or nothing, each building on
the previous level. 0 (default) is hard errors. 1 is connection
error debugging info. 2 is all connection info. 3 is more state
info. 4 includes all message info.
* Add some hopefully useful comments
This commit was SVN r14261.
